Show in Contents
Add to Favorites
Home: Softimage User's Guide
Share
Torus Property Editor
Properties Reference
Add Edge Op Property Editor
Properties Reference
>
Topology Modifier Properties
Topics in this section
Add Edge Op Property Editor
Bevel Op Property Editor
Boundary Curve Adaptor Property Editor
Clean Curve Property Editor
Clean Surface Property Editor
Curve Boundary Adaptor Property Editor
Curve Point Adaptor Property Editor
Curve Shift Property Editor
Dice Polygons Op Property Editor
Disconnect Component Op property editor
Edge Filter Op Property Editor
Extend to Curve Property Editor
Extract Edge Loop Property Editor
Extrude Normal Op Property Editor
Extrude Op Property Editor (Components along Axis)
Extrude Op Property Editor (Components along Curve)
FilterPointsByDistance Op Property Editor
GATOR Property Editor
Insert Crv Knot Op Property Editor
Insert Surface Knot Property Editor
Inverse Curve Property Editor
Inverse Normals Property Editor
Mark Hard Edge/Vertex Property Editor
Mesh Local Subdivision Op Property Editor
Open/Close Surface Property Editor
Polygon Filter Op Property Editor
Polygon Reduction Op Property Editor
Quadrangulate Op Property Editor
Raise Crv Degree Op Property Editor
Remove Curve Knot Op Property Editor
Remove Surface Knot Property Editor
Reparameterize Curve Property Editor
Reparameterize Surface Property Editor
Set Crv Knot Multiplicity Op Property Editor
Set Edge/Vertex Crease Value Property Editor
Slice Polygons Op Property Editor
Snip Surface Property Editor
Spin Edge Op Property Editor
Split Edge Op Property Editor
Split Polygon Op Property Editor
SubdivideEdge Op Property Editor
SubdividePolygon Op Property Editor
Surface Curve Adaptor Property Editor
Surface Shift Property Editor
Surface UV Swap Property Editor
Symmetrize Polygon Op Property Editor
Trim Surface with Space Curve Property Editor
WeldEdges Op Property Editor
WeldPoints Op Property Editor