Evaluate > Surface Evaluate > Highlights
 
 
 

Creates curves-on-surface corresponding to highlight lines produced by light sources.

Highlights Control

Light Origin

The 3D coordinates of the origin of the first light (center point).

You can set the origin with the highlight manipulator when you use the tool.

Direction Type

Select either Rotation or Vector.

Light Direction

The direction in which the light sources point.

You can set this vector with the highlight manipulator when you use the tool.

Number of Lights

The number of lights from which to create curves-on-surface highlights.

If you use more than one light, the multiple lights are always parallel to each other.

Light Width

The width of the single light source. This option is only available if Number of Lights is 1.

Set the width to 0 to create a single curve-on-surface. Set the width greater than 0 to create two curves-on-surface corresponding to the edges of a wide highlight.

This option has no effect if Visual is turned on.

Light Spacing

The spacing between multiple light sources. This option appears when Number of Lights is greater than 1.

Vector/Plane/Point

Enter the name of a point/vector/plane to position/align the Surface Evaluate manipulator with it. (You can also click a point/vector/plane to align the Surface Evaluate manipulator with it. Or you can select the point/vector/plane and the surface before selecting the tool.)

Subdivisions

The quality of the curve-on-surface projection, from 1 to 6. The higher the value, the more precise the result. Use low values for draft quality, use higher values for final results.

Visual

Draw fast polylines instead of curves-on-surface.

These lines are mainly for display purposes. Although you can pick them (to delete them, for example), you cannot use them to create geometry.

Tolerance
When Visual is checked on, this value defines the quality of the visual curves independently of the tessellation tolerance. This lets you set the visual tolerance to a smaller value to get better quality visual curves, without reducing the tessellation tolerance used for shading.

Left: visual tolerance = 0.1 mm. Right: visual tolerance = 0.001 mm

Control Options

Create History

Save the history of the new curves-on-surface for later editing. If you turn Create History on, you can modify the surfaces and the curves-on-surface update.

Auto Recalc.

Update the curves-on-surface as you change the values in the window.

Buttons

Recalc

When Auto Recalc. is off, use this button to update the curves on surface to correspond to the current options.

Undo All

Undo all the changes made by the tool and return to the original surface.

Next

Finish creating curves-on-surface on the current surface and prompt for a new surface to evaluate.

See Also