Checks the position, tangent, or curvature continuity between curves, and displays a locator showing the deviation.
Curve Continuity Options
-
-
The initial scale of the lines which show the tangents of the two curves. The actual length of the lines is proportional to
the angle times this scaling value.
You can change this value when you use the tool by holding and dragging the .
-
-
The initial scale of the lines which show the curvature of the two curves. The actual length of the lines is proportional
to the angle times this scaling value.
You can change this value when you use the tool by holding and dragging the .
-
-
Creates a persistent locator that displays the continuity between curves (that is, the locator remains even after the tool is no longer active). This allows you to monitor curve continuity as you edit curves.
-
-
The locator appears only as a green circle (the curves are continuous) or a red circle (the curves are not continuous).
-
-
Displays a locator that indicates whether the two curves are , , or continuous.