The following table shows the recommended workflow for the 3D Keyer.
| Step: | Refer to: |
|---|---|
| 1. Open the Modular Keyer, select the clips, and then open the 3D Keyer. | Accessing the 3D Keyer. |
| 2. Sample for tolerance. | Setting the Tolerance. |
| 3. Sample for softness. | Setting the Softness. |
| 4. Minimize the noise in softened areas. | Removing Noise from Softened Areas. |
| 5. Remove grey areas from the key using negative sampling and patches, garbage masks, or RGB colour and softness adjustment. | Removing Grey Areas in the Key, Garbage Masks, Techniques for Adjusting Softness. |
| 6. Adjust the luminance of the key. | 2D Histogram Node. |
| 7. Adjust the edges of the key. | Matte Edge. |
| 8. Remove colour spill. | Colour Curves Node. |
| 9. Adjust front and back matte curves. | Result Node. |
| 10. Process the clip. | Processing Options. |
