Show in Contents

Add to Favorites

Home: Smoke

 

Removing Grain from a Clip

Adding and Removing Film Grain

Adding Grain Using a Preset Grain Signature

 

Pre-processing > Adding and Removing Film Grain > 

Adding Grain to a Clip

Use the ReGrain command to restore the film grain on a clip that had been degrained, or to add grain to a clip originating on video or CG so as to make it look like film.

ReGrain synthesizes preset or custom grain signatures by modulating noise according to the luma of the image. This modulation is defined by granularity curves that specify the gain for the luma values of each channel.

• When you use a preset grain signature, these curves are implicit in the menu controls.
• When you define a custom grain signature, you work with these curves directly.

To access ReGrain from the EditDesk:

1. From the A/V Tools box, select and enable Film, then click ReGrain.

   
   

2. From the Input Mode box that appears, select Front.
3. Select the clip to which you want to add grain, and then select the destination for the processed clip.

   The ReGrain menu appears.

   
   

   (a) View box  

4. Optional: Click Reset All, and then Confirm to reset ReGrain to the default settings.

   
   

5. By default, the result clip appears. You can also view the front clip by selecting Front from the View box.
6. To view the front and result clips simultaneously, and to speed up interactivity while defining the ReGrain parameters, use the crop box. See Defining the DeGrain and ReGrain Area.