Calibrating for Dual-Head Mode			Applying 3D Mesh LUTs
Chapter 5, Monitor Calibration

Topics on this Page:

Selecting Print LUTs

Switching between Print LUTs

Use Print LUTs, obtained from your film lab, to apply preset gamma correction. Print LUTs are specially designed by your lab to ensure an accurate display of your film stock images by simulating a film print look. Print LUTs may be updated several times a day to ensure proper calibration with the lab.

Note: In Lustre, LUTs used to calibrate the monitor are applied from the 16-bit result buffer and have a higher quality than those produced on the graphics card.

Selecting Print LUTs

You can select up to three Print LUTs for quick comparison in a project. When your lab sends you the latest LUT, simply select it from the Calibrate menu. You can have any number of Print LUTs on the system.

1. In the Calibrate menu, click 1.

   

2. Select a Print LUT from the Print LUT list.

   

   The Print LUT is assigned to L1.

   

3. Repeat steps 1 and 2 to assign a Print LUT to L2 and L3.

Switching between Print LUTs

You can switch between Print LUTs to change the display of your images anytime during a session.

• Do one of the following:

  • In the Calibrate menu, click 1, 2, or 3.

  • Click the LUT button to toggle through the selected Print LUTs.

  

  The selected Print LUT is applied to the display.