Adjust retargeting parameters
 
 
 

To adjust retargeting parameters

  1. Select Skeleton > HumanIK from the main menu bar to open the HumanIK window.
  2. From the HumanIK window menu bar, select Retarget > Select Retarget Settings Node.

    The retargeting settings display on the HIKProperty2State tab in the Attribute Editor.

    NoteThe Property2State node also includes many other HIK solver attributes such as Solving and Floor Contact that do not apply to the retargeting process. Those attributes are beyond the scope of this documentation.
  3. Expand the Retarget Specific heading.

    This section contains attributes that give you finer control over the retargeting between your source and target characters. See Retarget Specific attributes for more information.

  4. Expand the Reach heading, then drag the slider or type a value in the numerical field for each body part you want to adjust.

    Use the following guidelines when manipulating the Reach sliders:

    • At 100%, the target body part reaches fully toward the source body part.
    • At 50%, the target body part averages between the body part of the source and the character’s position.
    • At 0%, the effect on the body part is the same as disabling the option.
    NoteThe Retarget Specific section also includes Pull and Resist attributes. Adjusting these values is an advanced technique and for normal retargeting, adjusting the default values is not recommended.

Related topics