IK Handles On/Off Options

Command

Tgl – The IK handles’ states will be toggled. That is, if an IK handle is ON then it will become OFF, or if OFF will become ON.

Tgl Unify – If the selected IK handles are either all on or all off, then this behaves the same as Tgl.

If some of the selected handles are on and others off, then the first use of this control will set them all to the same state—subsequent use of this control will then behave the same as Tgl.

On – Forces all IK handles to be ON.

Off – Forces all IK handles to be OFF.

Objects

Active – Only the active IK handles are affected.

All – All existing IK handles are affected.

Hierarchy

None – Changes state for IK handles only.

Above – If a joint is used, all IK handles relative to the joint and the joints above it may be changed.

Below – If a joint is used, all IK handles relative to the joint and the joints below it may be changed.

Single Chain

If set OFF, no Single-Chain IK handles will be changed.

Multi Handle

If set OFF, no Multi-Chain IK handles will be changed.

Spline Handle

If set OFF, no Spline handles will be changed.

Note

At least one of the three types is always ON.