Extrude Vertices/Edges (Polymesh)

Command entry:Select an Edit Poly or editable poly object.

Modify panel

Vertex/Edge/Border sub-object level

Edit Vertices/Edges/Borders rollout

Extrude

(Settings)

Command entry:Select an Edit Poly or editable poly object.

Vertex/Edge/Border sub-object level

Quad menu

Tools 2 quadrant

Extrude

(Settings)

Command entry:Select an Edit Poly or editable poly object.

Modeling ribbon

Graphite Modeling Tools tab

Polygon Modeling panel

(Vertex) or

(Edge) sub-object level

Vertices or Edges panel

Shift+click

(Extrude) or choose Extrude Settings from the drop-down list.

Use these settings for extruding vertices, edges, and borders in Interactive Manipulation mode.

NoteAt the Border sub-object level, this caddy is named Extrude Edges.

Interface

For details on using the caddy controls, see The Caddy Interface.

Extrusion Height: Specifies the amount of the extrusion in scene units.

You can extrude sub-objects outward or inward, depending on whether the value is positive or negative.
Extrusion Base Width: Specifies the size of the extrusion base in scene units.

You can set this as high as you want, but the actual size cannot extend beyond the vertices adjacent to the extruded sub-object(s).

_____

OK: Applies the settings to the current selection and closes the caddy.
Apply and Continue: Applies the settings to the current selection, retaining them for the preview if you then change the selection.
Cancel: Closes the caddy without applying the settings to the current selection. Does not reverse previous uses of Apply.