bend

The following attributes display in the Nonlinear Deformer Attributes section of the Attribute Editor when you select a bend deformer node, as INPUTS of the bend node in the Channel Box. You can also set these attributes as you create a bend node using the Create Bend Deformer Options (Create Deformers > Nonlinear > Bend > ).

Curvature

Specifies the amount of bending, in degrees. Negative values specify the bending towards the bend deformer’s negative X-axis. Positive values specify the bending towards the deformer’s positive X-axis. Use the slider to select values from -230 to 230. Default is 0, which specifies no bend.

Low Bound

Specifies the lower extent of the bending along the bend deformer’s negative Y axis. Values can be negative numbers or zero. Values can be negative numbers or zero. Use the slider to select values from -10.0000 to 0.0000. Default is -1.0000.

High Bound

Specifies the upper extent of the bending along the bend deformer’s positive Y axis. Values can be positive numbers only (minimum is 0.0000). Use the slider to select values from 0.0000 to 10.0000. Default is 1.0000.

 Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License