Setting fluid shading attributes

You can set the fluid shading properties using attribute ramps. In this section, you add color and incandescence to the Density and Temperature and adjust the fluid opacity.

To set fluid shading attributes

1. In the Shading section of the fluid_slag_smokeShape tab in the Attribute Editor, click the Transparency color swatch, and set the color to the following values:
   • R: 0.5
   • G: 0.5
   • B: 0.5

   With a low transparency value, you can clearly see the smoke being emitted from the slag. After you set the Incandescence ramp, you can re-adjust the transparency if necessary.

2. Set Edge Dropoff to 0.025.
3. In the Color section, click the color swatch and set the color to following values:
   • R: 0.546
   • G: 0.466
   • B: 0.443
   
4. Set Color Input to Constant.
   
5. In the Incandescence section, create a ramp using the following values:

   Marker	Selected Position	RGB color values
   1	0.5	black
   2	0.7	R: 0.23, G: 0.035, B: 0.06
   3	0.8	R: 0.46, G: 0.071, B: 0.011
   4	1.0	R: 3.0, G: 0.90, B:0.072

   Leave all of the marker Interpolation values set to Linear.

6. Set Incandescence Input to Temperature.
7. Set Input Bias to 0.53.
   
8. In the Opacity section, create a ramp using the following values:

   Marker	Selected Position	Selected Value
   1	0.1	0
   2	0.2	0.2
   3	1.0	1.0

   Leave all of the marker Interpolation values set to Linear.

9. Set Opacity Input to Density.
10. Set the Input Bias to 0.5.
    
11. Rewind and play the simulation.

    The fluid still does not look like real smoke and flames. This is because the fluid resolution is still too low. In the next section, you increase the resolution and improve the solve quality.