Nonlinear Deformer Attributes
Select one of the following
options.
- Low Bound
-
Specifies the lower extent of squashing
(or stretching) along the deformer’s local negative Y axis. Use
the slider to select values from -10.000 to 0.000. Default is -1.000.
- High Bound
-
Specifies the upper extent of squashing
(or stretching) along the deformer’s local positive Y axis. Use
the slider to select values from 0.000 to 10.000. Default is 1.000.
- Factor
-
Specifies the amount of squashing or stretching. Increasing
negative values specify squashing along deformer’s local Y axis
and increasing positive values specify stretching along deformer’s
local Y axis. Use the slider to select values from -10.000 to 10.000.
Default is 0.000 (no squashing or stretching).
- Expand
-
Specifies the amount of expansion outwards during
squashing or inwards during stretching. Minimum value is 0 and maximum
value is 10. Use the slider to select values from 0.000 to 10.000.
Default is 1.000.
- Max Expand Position
-
Specifies
the center of maximum expansion between the high bound position
and the low bound position. Values can be between 0.010 (near the
low bound position) to 0.990 (near the high bound position). Use
the slider to select values from 0.010 to 0.990. Default is 0.5.
When you set this attribute, the value is reflected in the with
the Max Expand Pos channel in the Channel
Box.
- Start Smoothness
-
Specifies
the amount of initial smoothing towards the low bound position (along
the deformer’s local negative Y axis). Use the slider to select
values from 0.000 to 1.000. Values can be from 0.000 to 1.000. Default
is 0.000.
- End Smoothness
-
Specifies
the amount of final smoothing towards the high bound position (along
the deformer’s local positive Y axis). Use the slider to select
values from 0.000 to 1.000. Default is 0.000.