Nonlinear Deformer Attributes
Select one of the following
options.
- Low Bound
-
Specifies lower extent of the flare
on the deformer’s local negative Y axis. Values can be negative
numbers or zero. Use the slider to select values from negative 10.000
to 0.000. Default is -1.000.
- High Bound
-
Specifies upper extent of the flare
on the deformer’s positive local Y axis. Values can be positive
numbers only (minimum value is 0). Use the slider to select values
from 0.000 to 10.000. Default is 1.000.
- Start Flare X
-
Specifies the amount of flaring from
the deformer’s X axis at the Low Bound.
The flaring progresses along the deformer’s local X axis, varying
according to the value of Curve. Use
the slider to select values from 0.000 to 10.000. Default is 1.000.
- Start Flare Z
-
Specifies the amount of flaring from
the deformer’s Z axis at the Low Bound.
The flaring progresses along the deformer’s local Z axis to the High
Bound, varying according to the value of Curve.
Use the slider to select values from 0.000 to 10.000. Default is
1.000.
- End Flare X
-
Specifies the amount of flaring from
the deformer’s X axis at the High Bound.
The flaring starts at the Low Bound and
progresses along the deformer’s local X axis to the High
Bound, varying according to the value of Curve.
Use the slider to select values from 0.000 to 10.000. Default is
1.000.
- End Flare Z
-
Specifies the amount of flaring from
the deformer’s Z axis at the High Bound.
The flaring starts at the Low Bound and
progresses along the deformer’s local Z axis to the High
Bound, varying according to the value of Curve.
Use the slider to select values from 0.000 to 10.000. Default is
1.000.
- Curve
-
Specifies the amount of curvature (the profile
of the flaring curve) between the Low Bound and the High
Bound. A value of 0 specifies no curvature (linear interpolation).
Positive values specify outward, bulging curvature and negative values
specify inward, hourglass-shaped curvatures. Use the slider to select
values from -3.000 to 3.000. Default is 0.000.