Command entry:Activate a Perspective or orthographic viewport.
Viewport Navigation controls
(Zoom)
Command entry:Keyboard
Alt+Z turns on Zoom ;
[ zooms in;
] zooms out
Command entry:Keyboard
Ctrl+Alt+middle mouse button (drag)
Command entry:Roll your mouse scroll wheel.
When Zoom is active, you can adjust the view magnification by dragging in a Perspective or orthographic viewport. By default,
zooming occurs from the center of the viewport.
TipIf you use a wheel mouse, you can turn the wheel to zoom the active viewport in and out without first activating Zoom. The
zoom center is the center of the viewport.
Zooming takes place incrementally, based on the distance between the viewpoint and its “virtual target,” an inaccessible hidden
target used for calculation purposes only. Use the Ctrl and Alt keys, respectively, to increase or decrease the increments. You can move the virtual target by holding down the Shift key during a zoom operation. Otherwise you will zoom increasingly closer to the target, which does not move.
Procedures
To zoom a view:
- Activate a Perspective or orthographic viewport.
- Click (Zoom).
The button highlights when it is on.
- Drag in a viewport to change magnification:
- Drag upward to increase magnification.
- Drag downward to decrease magnification.
- To exit Zoom mode, press Esc or right-click in a viewport.
To increase zoom speed:
- Hold down Ctrl as you drag in a viewport.
To decrease zoom speed:
- Hold down Alt as you drag in a viewport.
To turn on an automatic zoom mode:
- On the keyboard, hold down Ctrl+Alt, then hold down the middle mouse button and drag in a viewport. This does not activate the Zoom button.
To zoom from the keyboard:
- On the keyboard, press [ (left bracket) to zoom in, and ] (right bracket) to zoom out.