Command entry:Select a NURBS object.
Modify panel
Create Points rollout
Dependent Points group box
Offset Point button
Command entry:Select a NURBS object.
Modify panel
NURBS toolbox
(Create Offset Point)
This command creates a dependent point that is coincident to an existing point or at a relative distance from an existing
point.
Procedures
To create a dependent offset point:
- In the NURBS toolbox, turn on (Create Offset Point).
- In a viewport, click an existing point.
- On the Modify panel Offset Points rollout, use the Offset spinners to adjust the points position relative to the original point.
Interface
While an offset point sub-object is selected, the Offset Point rollout appears.
- At Point
-
When chosen, the dependent point has the same location as the original, parent point.
- Offset
-
Enables point offset. Use the X,Y,Z Offset spinners to set offset values (in object space coordinates).
- Replace Base Point
-
(Only at modification time.) Lets you replace the parent point. Click the button, then click the new point on which to base
the offset point.
