Paint Options Panel
 
 
 
Command entry:Modeling ribbon Freeform tab Paint Deform panel Enable a tool other than Shift (Push/Pull, Noise, and so on).

This panel opens when Paint Deform tools other than Shift are active, and provides settings for modifying their effects.

NoteOnly Size and Strength settings are available for Relax/Soften, Flatten, Pinch/Spread, Smudge, and Revert; additional settings are available for the rest. Also, values for any common parameters, such as Size and Strength, are shared among all tools. To store and restore different combinations of brush settings, use the Defaults panel.

Interface

Paint Options panel on minimized ribbon

Size

The radius of the circular deform brush.

NoteWith most brushes, you can change the size interactively by dragging with Ctrl+Shift held down.
Strength

The overall rate at which the deform tool deforms an object. For subtler effects, lower the Strength value.

NoteWith most brushes, you can change the strength interactively by dragging with Shift+Alt held down.
Offset
The extent by which dragging the brush deforms the mesh.

When Cap Offset is on (see following), repeated passes over the same area without starting a new stroke stop at the Offset amount.

NoteWhen the modeling ribbon is maximized or the Paint Options panel floats, the following controls appear on the Paint Options panel expansion.
Cap Offset

When on, dragging the brush continously stops deforming at the Offset amount (see preceding). To increase the offset, release the mouse button and then start again.

When off, dragging the brush continously keeps applying the offset without limit.

Normal Direction

Choose the direction in which mesh deformation occurs when painting:

  • OriginalUses the normals that the vertices had when you began using the tool.

    This way you can keep adding strokes without having the vertices go off in unexpected directions.

  • DeformedThe normals are updated after each stroke so the tool keeps pushing from the current state.
  • BrushUses the normal from the brush (gizmo) when you started the stroke.
  • ViewPushes towards or away from the view direction.
  • Transform X/Y/ZMoves vertices along the corresponding world axis.
Refresh Normals

Resets the brush to use each polygon’s current normal direction when deforming, rather than the original. Available only with Normal Direction=Original.

When off, painting always deforms in the original direction of the polygon’s normal.

TipFor automatic refreshing of the deform direction, set Normal Direction to Deformed (see preceding).
Brush Options

Opens the Painter Options dialog for adjusting brush properties, display options, and more.

Noise Options

These settings apply only to the Noise brush:

  • SeedGenerates a random starting point for the noise deformation from the number you set. Affects only subsequent painting, not existing results.
  • ScaleSets the size of the noise effect (not strength). Larger values produce smoother noise, lower values more jagged noise.
  • TurbulenceDetermines the extent of noise variation. Lower values are less rough than higher values.