Fire

DEPRECATED. This shader is unsupported, but it may still get installed with Softimage to provide compatibility with older scenes that use it. It is recommended that you replace unsupported shaders in your scenes with equivalent shaders from the current Softimage shader library.

| Flame Controls | Peekaboo

Shader Type: Material (Soft3D)

Output: Color (RGB) value

Simulates a surface projection fire effect. This shader does not create a volumic effect.

Name	The shader's name. Enter any name you like, or leave the default.

Flame Colors

Hot	Defines the fire's most intense color, usually at the base of the flame.
Medium	Defines the color of the flame's body.
Cool	Defines the color of outside edge of the Medium flame color.
Cold	Defines the coolest, or most peripheral areas of a flame.

Flame Controls

Burn Speed	Controls the flicker intensity over time.
Rise Speed	Controls the height fluctuation of the flames over time.
Scaling	Controls the relative size of the flames.
Maximum Height	Defines the highest point the flames will reach. Measured in SOFTIMAGE units.
Streak	Defines the contrast between the flame colors to create a streak effect.
Complexity	Controls the blending complexity of the various flame colors.
Intensity	Controls the intensity of the effect's colors. Careful, however, using too high a value may heat your monitor unnecessarily.

Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License