Lagoa Air Wind

 
 
 

This node generates a directional force with strength that respects the density of the points; for example, points inside a pile won't be affected by the wind.

You could also use the Wind Force node to create a wind force.

Tasks: Lagoa/Forces

Output Ports: Force Vector

Air Contrast Curve

This profile curve is the contrast between air and the points' mass, allowing you to control the interface between air and the simulated points. For example, if there 's a pile of dust and the wind starts blowing, only the points that reach the highest point of contrast in this curve will be affected by the wind. Points that are lower on the contrast curve are more likely to be occluded from the wind. For example, the wind won't reach points inside a pile because they are occluded by other points.

Wind Direction

The direction of the wind in XYZ.

Intensity

The strength of the wind applied to the points.

Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License