Splits one or more faces on a polygon mesh into multiple faces after you specify the split location on the mesh.
> 
NoteYou can also access the by selecting a polygon, pressing
+ space bar +
, selecting from the marking menu, and then swiping east.
-
-
Constrains any points you make to the edges. If you wish to make points on faces, uncheck this checkbox.
-
-
Controls the number of snapping point inside edges. For example, 5 means that there are magnet points at each end and five
in the middle.
-
-
Controls how close a point must be to a magnet before the point snaps to it. Set this to 10 to constrain points to always
be at magnet points.
-
-
Each color distinguishes a marking lines or point used when splitting a face. Colors can be changed by double-clicking them.
NoteThe is a pre-select highlight that allows you to see what edge or face you will be marking.
TipYou can snap to points that have already been created using the option, either by turning it on in the status line or by using the hotkey.
