Edit deformer set membership

 
 
 

You can directly edit deformer set membership with the Edit Membership Tool.

To edit deformer set membership with the Edit Membership Tool

  1. Select Edit Deformers > Edit Membership Tool.
  2. Select the deformer you want to edit.
  3. Go into component selection mode (click the select by component type icon).

    The members of the deformer set whose joint you selected are displayed in yellow. This set is the currently selected set. Members of other sets are displayed in other colors. Points displayed in dark red are not in a set.

  4. To add points to the currently selected set, -click the points.

    The selected points are now displayed in yellow, indicating they are in the currently selected set.

  5. To remove points from the currently selected set, -click the point.

    The selected points are now displayed in dark red, indicating they are currently not in a set.

  6. Click the Select Tool to quit the editing mode.

Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License