When
preparing for a clip input and output session, confirm the following:
- Audio and video outputs of the VTR are
connected to the audio and video inputs of the Flame system.
Audio and video inputs of the VTR are connected to the audio and
video outputs of the Flame system.
- The VTR is connected, using an RS-422
video I/O control cable, to a serial port of your workstation to
enable remote control of the device.
- A video sync signal is connected to the
sync input of the video device to ensure frame-accurate capture.
If there is a separate audio device, an audio sync signal must be
connected to it as well.
Video hardware configuration
procedures are detailed in the “Setting Up Video Hardware” chapter
of the Hardware Setup Guide for your
workstation..
