Keep
in mind the following when selecting clips to use as logos:
- If the clip has more than one frame,
only the first frame is used.
- A clip that is Burn pending, unlinked
or unlinked HiRes, cannot be used.
- The higher the resolution for the clip,
the more impact it has on the capacity of the application to output
in real time.
Logo settings are persistent,
and are reloaded the next time you open the Output Clip menu.
NoteThe same logo, with
its settings, is applied to all clips for which you have checked
the Logo column in the Output Clip list.
To insert a logo in real time:
- Access the Output Clip menu as described
in
Outputting Clips To a VTR.
- In the Output Clip menu, use the Logo
column to indicate the clips on which to overlay the logo.
- Click the Logo tab to access the logo
controls.
- Select one or two clips to be used as
your logo:
- If you select one clip, it is used as
the front clip and a luminance key is applied to it. If the clip
has multiple frames, only the first frame is used.
- If you select two clips, the first is
used as the front and the second as the matte.
- Use the logo controls to position and
configure the appearance of your logo, and to define in and out
points. See
About the Logo Controls.
- Output the clip.
