Show in Contents

Add to Favorites

Home: Flame

 

Pasting Text from an External Source

Changing Fonts

Sparks

 

Effects > Text > Changing Fonts > 

Entering Non-Latin Text

When entering non-Latin text characters make sure the required kinput2, canna, and Wnn6 packages are installed.

The following example illustrates entering Japanese text in a text layer.

To enter Japanese text in a text layer:

1. Start the canna daemon by typing /etc/init.d/canna start in a Linux terminal.
2. Type the following commands in the terminal:
   • kinput2 -canna &
   • setenv XMODIFIERS @im=kinput2
   • setenv LANG ja_JP.eucJP
     NoteFor detailed instructions on kinput, canna, and Wnn6, consult your system documentation.
3. Start your Autodesk application.
4. Load a clip in the Text module.

   Notice the message bar that appears at the top of the screen. This indicates you are in Latin input mode.

   
   

   (a) Message bar  

5. Create a layer and click the Font field to select a Japanese font from the file browser. From the Text Mode box, select Edit and then select the layer in the image window.

   When you type text, notice that you are still in Latin input mode.

   
   

6. Press your Input Method hot key.

   The message bar changes to indicate that you are in Japanese text mode.

   
   

   (a) Message bar  

7. Type text, as required.
8. Press Enter to accept the characters and add them to the text layer.

   
   

9. To revert back to Latin input mode, press the Input Method hot key again.