You can increase or decrease
the number of points in freehand segments of a mask by adjusting the
Lasso Fit value. An entire garbage mask can consist of freehand
segments, in which case the Lasso Fit value affects the whole garbage
mask. Otherwise, the Lasso Fit value only affects the part of the
mask drawn freehand.
The Lasso Fit parameter
loses its influence over freehand segments of a mask if you have
edited points as follows:
- Added or deleted points using the Add
or Delete Edit modes
- Saved and loaded a garbage mask
- Started a new session with the application
To adjust the number of vertices using
Lasso Fit:
- If necessary, select the garbage mask
you want to affect.
- Drag the Lasso Fit field. Increase the
value to decrease the number of points in the freehand segments
of the mask. Decrease the value to increase the number of points
in the freehand segments.
Segments of the mask
that have been drawn freehand are affected, while segments created
by simple clicks remain unaffected.
NoteIf you move vertices
of a garbage mask and then change the Lasso Fit value, all the vertices
snap back to the original position where they were first drawn,
and all animation is lost. This occurs only if the Lasso Fit value
retains its influence on the garbage mask.