Show in Contents

Add to Favorites

Home: Lustre

 

Incinerator-Specific Project Management Configuration

Project Management

Project Configuration

 

Project Management > 

Configuring System Settings

After Lustre is installed but before launching it for the first time, you must configure system-level settings in the init.config file.

You only define these system settings once, unless your system workstation configuration changes. For more information about the init.config file, including default settings, refer to the “Software, Project, and User Configuration Files” chapter in the Lustre Software Installation Guide.

To configure the system settings:

1. Open the init.config file in a text editor. The location of the file depends on the workstation's operating system.

   Operating System:	Location:
   Windows	C:\Program Files\Autodesk\Lustre 2009.1
   Linux	/usr/autodesk/lustre_2009.1

2. Edit the init.config file as required to define:
   • BrowseD. See the Configuring BrowseD section in the Lustre installation guide for your operating system.
   • Wiretap
   • Calibration settings
   • Autodesk Control Panel
   • Slave Render
   • Backburner
   • Internal keywords
   • DPX keycode emulsion list
3. Save your changes and exit the text editor.