Show in Contents

Add to Favorites

Home: Inferno

 

Copying and Pasting Meshes for a Still Clip

Warper

Defining the Source Mesh

 

Effects > Warper > 

Warping

Warping changes the shape of the image in a clip. When you warp an image, you start by drawing a mesh over the region of the image you want to warp. You then modify the mesh over the image at specific keyframes to distort the image.

To create the warp, define a source mesh and a destination mesh for the front clip. The source mesh defines the area of the image that you want to warp; it outlines the shape of the non-distorted image in each frame of the clip. The destination mesh defines what the warped image looks like; it outlines the shape of the distorted image in each frame of the clip. Typically, you set the destination mesh at several frames of the clip. The Warper generates a smooth transition between frames.

The general steps for warping:

1. Load the appropriate clips into the Warper. If you are warping just a region of the clip, load the same clip as the Front and the Back clip. See Warping a Region of a Clip.
2. In the Warper menu, click Warp.
3. Set up the clips. See Setting Up the Clips. In general:
   • Set Front to On.
   • If you are warping just a region of the clip, set Back to Lock.
4. Click Front to view the front clip.
5. Define the source mesh for the original image.
6. Define the destination mesh for the warped image.
7. Process the clip.