Editing > Editing to the Batch Timeline > 
Overwriting Clips in an Edit Sequence
 
 
 

When you overwrite existing material in the record clip with new material, the overall length of the record clip does not change. The result of the overwrite edit depends on how you perform the edit. In the following illustration, New Clip is edited gesturally at the transition between Clip A and Clip B. Clip B is overwritten. Clip A and Clip C are unaffected.

Show small imageShow large image

You can also edit a source clip into the record clip at any frame. The source will overwrite all existing material for its duration. In the following illustration, New Clip is edited into the record clip at a frame in Clip A. Frames after the insertion point are overwritten by New Clip. All of Clip B and some of Clip C are overwritten.

Show small imageShow large image

When you overwrite a section of the timeline with a source clip that contains gaps, there are two options:

Show small imageShow large image

To overwrite a clip at a transition gesturally in the schematic:

  1. Display the timeline for the edit sequence where you want to overwrite a clip.
  2. Disable Ripple.
  3. Select a Snap option.
  4. Press Ctrl+Shift and drag the source clip to the timeline.
  5. Drop the source clip where you want to make the overwrite.

    The edit sequence does not change duration to accommodate the new clip.

To overwrite a clip at a frame between transitions using the hot key:

  1. Set the clip where you want to make an overwrite as the record clip.
  2. Set the clip that you want to use as the overwrite as the source clip.
    NoteTo overwrite with material that starts at a specific frame, move the source timeline positioner to the frame that you want to use as the beginning of the overwrite.
  3. Go to the frame in the record timeline where you want to make the overwrite.
  4. Press O.