Project and Media Management > Clip Libraries > Copying Local and Remote Clip Libraries to Your Current Project > 
Disabling Auto-Connect from Outside the Application
 
 
 

Occasionally, a problem with a remote system that is auto-connected to your project can prevent Flint from loading. When this happens, the local system will freeze as you try to launch it and a message will appear in the shell indicating which remote system is unreachable. If this occurs, you can kill the application and then temporarily disable auto-connect using the following procedure.

To temporarily disable auto-connect:

  1. In a command shell, where you plan to launch the application, type:

    setenv DL_NETWORK_NO_AUTO_REIMPORT

    When you launch the application, the current configuration of auto-connected remote systems is not loaded.

    NoteThe next time you launch the application without using this environment variable, the auto-connected remote system is once again loaded.