Editing > Audio > Using Output Strips > 
Using the Limiter
 
 
 

The Limiter provides a form of signal compression. It allows audio signals below a set value to pass unaffected, and clips off the peaks of stronger audio signals that exceed the set value. The audio remains untouched unless the limiter is working, in which case only gain is affected. The built-in auto-release mechanism allows for fast recovery, minimizing distortion and pumping. The Limiter is a stereo effect that applies to a pair of output strips.

To set the limiter:

  1. In the AudioDesk, ensure that each audio input strip that you want to work with is assigned to an output strip.
  2. Toggle the meters to Desk Outputs.
  3. Play the clip.
  4. Note the audio output levels displayed on the meters.
  5. Enable the Limiter button.

    The Limiter meter appears.

  6. Adjust the Limiter level to remove any overloads, or to limit the peaks to a desired output level.