Each of the image generating tools has a common UI area where properties can be applied.
The following table lists the common property controls and their function.
| Property |
Description |
| Format |
Provides a selection of film formats. |
| Image Width/Height |
Sets the width and height of the image produced by the generator node. |
| Image Aspect Ratio |
Sets the image aspect ratio of the image produced by the generator mode. |
| Pixel Aspect Ratio |
Sets the pixel aspect ratio of the image produced by the generator mode. |
| Rate |
Sets the rate of the stream produced by the generator node. |
| Channels |
Sets the number of channels of the images produced by the generator node. Possible channel combinations are:
|
| Depth |
Sets the depth per channel (in bits) of the images produced by the generator node. Possible image depths are:
|
| Repeat |
Determines how the generator node outputs its result outside its source time range. Possible modes are:
- No Repeat: There is no repetition at all, the generator outputs black frames outside its time range.
- Hold: First and last frames are repeated.
- Loop: Repeats the entire sequence.
- Ping-Pong: Repeats the sequence from beginning to end, to beginning, and so on.
|
| Mark in/Mark out |
Defines the total number of frames the node generates for the image. |
| Start Time/End Time/Offset |
Defines the time range (and any offset required) where the generator node is to output a result. It follows global time. |
| Lock Duration |
Locks the Start/End time values. |
