Create Deformers >
Nonlinear > Squash >
Basic tab
- Low Bound
-
Specifies
the lower extent of squashing (or stretching) along the deformer’s
local negative Y axis. Use the slider to select values from negative 10.0000
to 0.0000. Default is -1.0000.
- High Bound
-
Specifies
the upper extent of squashing (or stretching) along the deformer’s
local positive Y axis. Use the slider to select values from 0.0000 to
10.0000. Default is 1.0000.
- Start Smoothness
-
Specifies
the amount of initial smoothing toward the low bound position (along
the deformer’s local negative Y axis). Use slider to select values
from 0.0000 to 1.0000. Default is 0.0000.
- End Smoothness
-
Specifies
the amount of final smoothing towards the high bound position (along
the deformer’s local positive Y axis). Use the slider to select
values from 0.0000 to 1.0000. Default is 0.0000.
- Max Expand Position
-
Specifies
the center of maximum expansion between the high bound position
and the low bound position. Values can be between 0.01000 (near
the low bound position) and 0.9900 (near the high bound position).
Use the slider to select values from 0.0100 to 0.9900. Default is
0.5000.
- Expand
-
Specifies the amount of expansion outwards during
squashing or inwards during stretching. Use the slider to select
values from 0.0000 to 1.7000. Default is 1.0000.
- Factor
-
Specifies the amount of squashing or
stretching. Increasing negative values specify squashing along deformer’s
local Y axis. Increasing positive values specify stretching along
deformer’s local Y axis. Use the slider to select values from -10.0000
to 10.0000. Default is 0.0000 (no squashing or stretching).
Advanced tab
See
Advanced deformer options.
- Deformation Order
-
Specifies
the placement of the deformer node in the deformable object’s history.
For more information about deformer placement, see
Deformation order.
- Exclusive
-
Specifies
whether the deformer set is in a partition. Sets in a partition
can have no overlapping members. If on, the Partition
To Use and New Partition Name options
become available. Default is off.
- Partition To Use
-
Lists
any existing partitions, and a default selection Create
New Partition. If you select Create New Partition,
you can edit the New Partition Name field to
specify the name of a new partition. Only available if Exclusive is
on.
- New Partition Name
-
Specifies
the name of a new partition that will include the deformer set.
The suggested partition name is deformPartition, which will be created
if it does not already exist. Typically, you might put all your
exclusive deformer sets in the partition named deformPartition.
However, you can create as many partitions as you like, and name
them whatever you want. Only available if Exclusive is
on.