Create Deformers >
Nonlinear > Bend >
Basic tab
- Low Bound
-
Specifies
lower extent of the bending along the bend deformer’s negative Y
axis. Values can be negative numbers or zero. Values can be negative
numbers or zero. Use slider to select values from -10.0000 to 0.0000.
Default is -1.0000.
- High Bound
-
Specifies
upper extent of the bending along the bend deformer’s positive Y
axis. Values can be positive numbers only (minimum is 0.0000). Use
slider to select values from 0.0000 to 10.0000. Default is 1.0000.
- Curvature
-
Specifies
the amount of bending. Negative values specify the bending towards
the bend deformer’s negative X axis. Positive values specify the
bending towards the deformer’s positive X axis. Use slider to select
values from -4.0000 to 4.0000. Default is 0.0000.
Advanced tab
See
Advanced deformer options.
- Deformation Order
-
Specifies
the placement of the deformer node in the deformable object’s history.
For more information about deformer placement, see
Deformation order.
- Exclusive
-
Specifies
whether the deformer set is in a partition. Sets in a partition
can have no overlapping members. If on, the Partition
To Use and New Partition Name options
become available. Default is off.
- Partition To Use
-
Lists
any existing partitions, and a default selection Create
New Partition. If you select Create New Partition,
you can edit the New Partition Name field to
specify the name of a new partition. Only available if Exclusive is
on.
- New Partition Name
-
Specifies
the name of a new partition that will include the deformer set.
The suggested partition name is deformPartition, which will be created
if it does not already exist. Typically, you might put all your
exclusive deformer sets in the partition named deformPartition.
However, you can create as many partitions as you like, and name
them whatever you want. Only available if Exclusive is
on.