Nonlinear Deformer Attributes

Select one of the following options.

Curvature

Specifies the amount of bending. Negative values specify the bending towards the bend deformer’s negative X axis and positive values specify the bending towards the deformer’s positive X axis. Use the slider to select values from -4.0000 to 4.0000. Default is 0.0000, which specifies no bending.

Low Bound

Specifies the lower extent of the bending along the bend deformer’s negative Y axis. Values can be negative numbers or zero. Values can be negative numbers or zero. Use the slider to select values from -10.0000 to 0.0000. Default is -1.0000.

High Bound

Specifies the upper extent of the bending along the bend deformer’s positive Y axis. Values can be positive numbers only (minimum is 0.0000). Use the slider to select values from 0.0000 to 10.0000. Default is 1.0000.