Surfaces > Boundary Surfaces

Creates a new surface from up to 8 boundary curves.

The N-sided tool does the following:

Creates a normal (four-sided) NURBS surface that simulates a blend between the boundary curves.
Trims the surface using the boundary curves to create the appearance of a surface with up to 8 sides.

Triangular surfaces created by N‑sided are not degenerate (that is, they do not have a zero-length side). The surfaces are only trimmed to appear triangular.

N-sided Control options

Continuity table

The Continuity Table displays one row for each boundary curve involved in the N-sided operation.

Use the pop-up menu next to each curve to set the level of continuity across that boundary.
Use the Continuity pop-up menu above the table to set the level of continuity across all curves at once.

Continuity: Free – This edge is free to move if required by another edge’s continuity.

Position – Only keep positional continuity. This is the default.

Tangent – Try to keep tangency with a surface that shares this edge.

Curvature – Try to keep curvature continuity with a surface that shares this edge.

If the number of sides is not four, all boundary curves are automatically rebuilt to create N-sided trimmed surfaces. In this case, the Rebuild checkboxes are disabled.

The Rebuild controls can only be used on four-sided (that is non-trimmed) surfaces:

Click the checkboxes at the end of each row to rebuild the curves to reduce data and improve parameterization.
Use the Rebuild pop-up menu to set rebuild on or off for all the curves at once.

Curve on Surf. Type: This option controls the degree of the curve on surface used to trim the new surface.

Linear – The trim edges will be linear curves (degree 1).

Cubic – The trim edges will be cubic curves (degree 3).

Note that Linear is much faster than Cubic.
Surface Degree: This slider controls the degree of the new surface (from 1 to 7). The default is 3.

Center Adjust Options

These options let you push or pull the surface toward or away from a center point. Center Height and Center Weight only appear when Center Adjust is on.

Center Adjust: Display the center adjustment sliders and a distance locator on the model.
Center Height: Increase or decrease the distance of the locator along the surface normal. This has the effect of pulling on or pushing in the center of the surface.
Center Weight: Increase or decrease the influence of the locator on the surface. Decreasing this value increases the distance between the center point you specify and the actual center point on the surface. The locator displays this distance.

Surface Continuity Feedback

Max. New Spans: Maximum number of spans the N-sided tool can insert in both U and V (on the initial untrimmed surface), as it tries to achieve continuity.

If the N-sided tool cannot achieve tangency without inserting more than the allowed number of spans, it displays an error in the prompt line.
Smoothing Weight: Use this slider to adjust the amount of smoothing to correct bumps and bulges. A higher weight smooths more.
Continuity Feedback Text: Click an edge name in the N-sided Control window to view the continuity feedback for that edge.

Lines of text indicate whether continuity was achieved. If continuity was not achieved, text boxes show how far out of tolerance the current edge is for each type of continuity.

For example, if an edge is 1 degree from tangency, and the tangency tolerance is 0.1 degrees, the tangent continuity feedback line shows 0.9 degrees.

Control Options

Create History: Save the history of the new surface for later editing. If you turn Create History on, you can modify the curves that were used to create the surface, and the surface will update.
Auto Recalc: Update the new surface automatically as you change the values in the N-sided Control window.

Buttons

Recalc: Recalculate the surface with the current values in the N-sided Control window.
Next: Finish the current surface and prompt for new curves.