Curve Edit > Fit Curve
 
 
 

Creates quality curves by fitting to cross-section line data, curves-on-surface, trim edges, isoparms (including surface edges and patch precision lines), and other free curves.

Fit Curve options

The default settings are as follows:

When you change these values, they are preserved for subsequent uses of the tool during the current session. You can save different combinations of options to a shelf.

Curve Name

Enter a name for the new curve.

Curvature

Turn on this option to show a curvature comb locator on the new curve.

You can change the comb scale and other settings through the Curvature tool in the Control Panel.

Deviation

Show a maximum deviation locator between the new and original curves.

Degree

Set the degree of the new curve. Increasing the degree allows a better fit, however not all CAD systems support curve degrees higher than 3.

Spans

Set the number of spans in the new curve. Increasing the number of spans gives a better fit, but also increases the complexity of the model.

Modify target

This option is only available when fitting a single curve to a curve-on-surface.

If it is checked on, a warning appears, saying that the target curve-on-surface might be modified, and its construction history deleted.

If you choose to proceed, the fitted-curve is projected onto the surface to create a new curve-on-surface. The fitting operation is repeated with the new curve-on-surface as the target. This process continues until a solution (within tolerance - see below) is found.

Max. CoS deviation

This slider controls the maximum lateral distance that the curve-on-surface (the target) is allowed to move when Modify target is turned on.

Buttons

Reset

Clicking this button removes all the fit curve segments on the current target curve. It also restores the original curve-on-surface if it was previously modified by Modify target, but does not restore its construction history.

See Also