Make a sculpt curve have the same amount of influence along its entire length

1. Choose CrvNet Tools > Influence Weights > Unit Weight.
2. Click the sculpt curve you want to change.

   The tool displays the current weight profile of the sculpt curve.

3. Drag left or right to change the weight of the curve, or type an exact value.
4. Click Go.

Set different amounts of influence at different points along a sculpt curve

1. Choose CrvNet Tools > Influence Weights > Multi Weight.
2. Click the sculpt curve you want to change.

   The tool displays the current weight profile of the sculpt curve.

3. Do any of the following:
   • Click the profile comb, then click again to insert a new needle for editing.
   • Click one of the labeled needles, then drag the to change the weight at that point in the profile.
   • Click one of the labeled needles, then drag the to move the needle in the profile.
   • Click one of the labeled needles, then click the to remove the needle from the profile.
4. Click Go.

Change a sculpt curve’s area of influence

1. Choose one of the region of influence tools:
   • CrvNet Tools > Region of Influence > Large region
   • CrvNet Tools > Region of Influence > Medium region
   • CrvNet Tools > Region of Influence > Small region
2. Click the sculpt curve you want to change, or drag a pick box around them.

Reset sculpt curves

Choose CrvNet Tools > Reset Sculpt Curves Mapping.