Star Spline
 
 
 
Command entry: Create panel (Shapes) Splines Object Type rollout Star
Command entry:Create menu Shapes Star

Use Star to create closed star-shaped splines with any number of points. Star splines use two radiuses to set the distance between the outer points and inner valleys.

Examples of stars

Procedures

To create a star:

  1. Go to the Create panel and turn on (Shapes).
  2. Click Star.
  3. Drag and release the mouse button to define the first star radius.
  4. Move the mouse and then click to define the second star radius.

Interface

Rendering and Interpolation rollouts

All spline-based shapes share these parameters. See Splines for explanations of these parameters.

Parameters rollout

Once you have created a star, you can make changes using the following parameters:

Radius 1

Specifies the radius of the inner vertices (the valley) of the star.

Radius 2

Specifies the radius of the outer vertices (the points) of the star.

Points

Specifies the number of points on the star. Range=3 to 100.

A star has twice as many vertices as the specified number of points. Half the vertices lie on one radius, forming points, and the remaining vertices lie on the other radius, forming valleys.

Distortion

Rotates the outer vertices (the points) about the center of the star. This produces a sawtooth affect.

Fillet Radius 1

Rounds the inner vertices (the valleys) of the star.

Fillet Radius 2

Rounds the outer vertices (the points) of the star.