Weld Vertices/Edges (Polymesh)

Command entry:Select an Edit Poly or editable poly object.

Modify panel

Vertex or Edge sub-object level

Edit Vertices/Edges rollout

Weld

(Settings)

Command entry:Select an Edit Poly or editable poly object.

Vertex or Edge sub-object level

Quad menu

Tools 2 quadrant

Weld

(Settings)

Command entry:Select an Edit Poly or editable poly object.

Modeling ribbon

Graphite Modeling Tools tab

Polygon Modeling panel

(Vertex) or

(Edge) sub-object level

Vertices or Edges panel

Shift+click

(Weld) or choose Weld Settings from the drop-down list.

Use this caddy for setting the weld threshold for vertices and edges and previewing the number of sub-objects to be welded.

Interface

For details on using the caddy controls, see The Caddy Interface.

Weld Threshold: Specifies the maximum distance, in scene units, within which selected sub-objects will be welded.

Any vertex or edge that lies outside this threshold (that is, it's farther than this from the nearest vertex or edge) will not be welded.
Before/After: Shows the number of vertices before and after the weld.

The After quantity updates dynamically as you change the setting.

_____

OK: Applies the settings to the current selection and closes the caddy.
Apply and Continue: Applies the settings to the current selection, retaining them for the preview if you then change the selection.
Cancel: Closes the caddy without applying the settings to the current selection. Does not reverse previous uses of Apply.