Surface-Curve Intersection Point
 
 
 
Command entry:Select a NURBS object. Modify panel Create Points rollout Dependent Points group box Surf-Curve button
Command entry:Select a NURBS object. Modify panel NURBS toolbox (Create Surface-Curve Point)

This command creates a dependent point at the intersection of a surface and a curve.

Procedures

To create a dependent surface-curve point:

The NURBS object must have a curve that passes through a surface.

  1. In the NURBS toolbox, turn on (Create Surface-Curve Point).
  2. Click the curve, then click the surface.

    The point is created at the intersection between the curve and the surface that is nearest the seed point. You can use the surface-curve parameters to trim the parent curve.

Interface

While a surface-curve intersection point sub-object is selected, a rollout with its parameters appears.

Trim Curve group

Trim

When on, trims the curve from the surface. When off, the curve isn’t trimmed.

Flip Trim

When on, trims the curve in the opposite direction.

Seed

Changes the Ulocation of the seed value on the curve. If there is a choice of intersections, the intersection closest to the seed point is the one used to create the point.

Replace Curve and Replace Surface

(Only at modification time.) Let you replace the parent sub-objects. Click a button, then click a curve or surface to replace the original parent object.