Reference > Properties Reference > Topology Generator Properties > 

Geometry Property Editor (Torus)

 
 
 

Controls the number of points on a primitive torus.

To apply: Choose Get Primitive Polygon Mesh Torus or Get Primitive Surface Torus.

To redisplay: Select the torus, click the Selection button on the Select panel, then click the Geometry icon.

Subdivisions

U, V

The number of segments in the corresponding directions. Higher subdivision values produce greater resolution and denser, heavier geometry.

Extent (Angles)

The Start and End U and V parameters let you open the torus along either direction. Values are in degrees.

Please send us your comment about this page

Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License