Deforms an object by bending it along one axis.
To apply: Select an object or cluster and choose from the Model toolbar.
To redisplay: Select the object then choose and click the tab.
|
|
Toggles the deformation on and off without affecting the values of other parameters.
|
Direction
|
|
The axis of the object's local coordinate space that is bent.
|
|
|
The direction in which the axis is bent, in degrees. For example, if the Y axis is bent in the direction 0 degrees, it bends
toward the X axis; if it is bent in the direction 90 degrees, it bends toward the Z axis.
|
|
|
Bends the bottom portion of the object, leaving the top undeformed. If this option is not checked, the top portion is bent
leaving the bottom portion undeformed.
|
Amplitude
|
|
The angle of the bend in degrees. You can type values outside the slider range.
|
|
|
The radius of an imaginary circle that describes the sharpness of the bend. The bend follows the circumference of this circle.
|
Deformation Center
|
|
Uses the center of the object's bounding box as the deformation center. If this option is not checked, the object's center
is used.
|
|
|
Offset of the deformation center from either the bounding box center or the object center in SOFTIMAGE units in the object's
local space. You can type values outside the slider range.
|
Deform 
Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License
