Syflex Cloth Springs
 
 
 

This compound defines the springs that are used to link a cloth object's set of points. There are three different types of springs that controlling a different kind of deformation on the cloth: stiffness, shearing, and bending.

For more information on springs, see Using the Syflex Spring Forces.

This compound is used in the Syflex Cloth compound.

Tasks: Syflex/Forces

Output Ports: The Force0/1/2 outputs each plug into the Force ports on the syflexISimul node, which controls the Syflex cloth simulation.

Stiffness

Defines the stiffness (stretch) of the springs that define the cloth. See Using the Syflex Spring Forces for information on springs.

A higher value makes the springs stiffer to resist deformation, while a lower value allows the cloth to become more elastic.

When you change the value of any of the spring parameters (Stiffness, Shear, or Bend), you should also change the Damping value accordingly.

Damping

The damp coefficient, which controls the intensity of the damping effect on all three types of cloth springs: Stiffness, Shear, and Bend.

When the cloth is very stiff, infinite oscillations (vibrations) may occur in the cloth. These vibrations can be avoided by increasing this value.

Increasing the damping may increase the computation time, so you should change this value in small increments and test until you get the look you want.

To start out, use a value that is approprimately one-tenth of the Stiffness value.

Shear

Defines the resistance of the shearing springs in the cloth. The shearing springs connect vertices with diagonal links across the face of the polygon mesh (like a fish net). These springs control the crosswise deformation on a cloth.

A higher value prevents shearing deformation, while a lower value allows the cloth to stretch crosswise.

This value is a percentage of the Stiffness value. Use values between 0 and 1: generally, keep this value between 0.4 and 0.8.

Bend

Defines the resistance of the bending springs in the cloth. The bending springs connect every other vertex on the cloth, which allows the cloth to bend.

A higher value prevents bending deformation, while a lower value allows the cloth's surface to bend more.

This value is a percentage of the Stiffness value. Use values between 0 and 1: generally, keep this value between 0.1 and 0.4.