Adjust camera properties to change the point of view for your scene. To open the Adjust Camera Properties dialog box, click View > Camera Properties:

To adjust perspective, drag the Adjust Perspective: Focal Length slider.

To change the camera height, drag the Adjust Height: Offset from Ground slider. You can move the camera both above and below ground level.

To adjust tilt, drag the Adjust Tilt: Offset from Vertical slider.

The Lens Distortion: Light Bloom controls enable light to spill over to neighboring pixels to create a glowing effect. Use the controls as follows:

• On: turns the effect on or off.
• Threshold: determines how bright pixels must be before light is allowed to spill over to neighboring pixels.

  Drag to the left to use a low threshold; all but the dimmest pixels will allow light to spill over, and the scene will look brighter.

  Drag to the right to use a high threshold; only brighter pixels will allow light to spill over. The glowing effect will not be as pronounced as one created with a low threshold, but will still be brighter than having no bloom effect at all.

• Intensity: controls the brightness of the affected pixels.
• Scale: controls the range of the effect; for example, the Large setting allows light to spill over to more pixels than the Small setting.

Bloom is not supported in ray tracing mode.

Use the Camera Position controls to specify an exact position for the camera.

Use the Lookat Position controls to specify the exact point of the scene to view with the camera.