Moving clips

You can move a clip in time and in space. Moving a clip along a track in the Story window alters the time at which its animation plays. Moving a clip in the Viewer window alters where and in which direction its assets move.

To move a clip:

1. Select a clip or many clips.
2. Drag the clip(s) left and right on the track.

   To move more than one clip at once, you can Ctrl-click each one to select them, then drag them. You can slash (/)-drag one clip to make all the clips to the right retain their distance from each other on the track.

To move a clip using its Clip In timecode:

1. Select a clip.
2. Double-click the clip.
3. Enter a new value in the Clip In timecode, and press Enter.
   

   A. Change the value of a Clip In timecode to move the clip.

   NoteDo not change the Clip Out timecode of a clip unless you want to trim the clip.

To change a clip’s trajectory in the Viewer window:

1. Select a clip in the Story window.
2. Translate and rotate it the Viewer window by manipulating its ghosts.

   Translating and rotating a clip’s ghost changes where the animation plays and in what direction. The ghost you select is the pivot point of the clip when you rotate it.

For example, in the next image, the start of the clip’s ghost clip vector is selected. The clip pivots around the selection. If part of the model ghost is selected instead, the clip rotates around that part.

You can also translate and rotate a clip in the Viewer window by changing the values in the Clip Offset T and Clip Offset R fields (A and B) that display in the Asset Settings window and Properties window. These settings display in the Asset Settings window and Properties window when you double-click a clip.

 Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License