Lets you deform selected guides by blending their shape towards the shape of a specified target guide
-
-
Sets the selected guide as the target guide.
-
-
Sets the amount of the target guide's shape that deforms the selected guides.
When set to 0, none of the target guide shape deforms the selected guides, while a value of 1 deforms the selected guides
based on their distance from the target.
-
-
Sets the amount that selected guides tilt in the direction of the target guide tip. is applied after .
-
-
Sets the weight of the selected guides deformation based on the distance from the target guide. Higher values decrease the
weight of the deformation based on distance. A value of 1 will have little or no effect.
-
-
Applies the blend shape settings to the selected guides.
-
-
Resets the target guide to its normal state.
Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License