Inflate nCloth

 
 
 

To inflate or deflate an nCloth object

  1. Select the nCloth object you want to inflate or deflate.
  2. In the Attribute Editor, select the nClothShape tab.
  3. Expand the Pressure section.
  4. Do one of the following for your nCloth:
    • For the Manual Pressure Settings, keyframe the Pressure attribute so that its value increases (inflation) or decreases (deflation).
    • For the Volume Tracking Model, set a Start Pressure and then keyframe the Pump Rate and Air Tightness. If your object has any holes in its surface, you can also keyframe its Seal Holes attribute for fast inflation or deflation.

Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License