Create Deformers > Nonlinear > Bend

 
 
 

Create Deformers > Nonlinear > Bend >

Basic tab

Low Bound

Specifies lower extent of the bending along the bend deformer’s negative Y axis. Values can be negative numbers or zero. Values can be negative numbers or zero. Use slider to select values from -10.0000 to 0.0000. Default is -1.0000.

High Bound

Specifies upper extent of the bending along the bend deformer’s positive Y axis. Values can be positive numbers only (minimum is 0.0000). Use slider to select values from 0.0000 to 10.0000. Default is 1.0000.

Curvature

Specifies the amount of bending. Negative values specify the bending towards the bend deformer’s negative X axis. Positive values specify the bending towards the deformer’s positive X axis. Use slider to select values from -4.0000 to 4.0000. Default is 0.0000.

Advanced tab

See Advanced deformer options.

Deformation Order

Specifies the placement of the deformer node in the deformable object’s history. For more information about deformer placement, see Deformation order.

Exclusive

Specifies whether the deformer set is in a partition. Sets in a partition can have no overlapping members. If on, the Partition To Use and New Partition Name options become available. Default is off.

Partition To Use

Lists any existing partitions, and a default selection Create New Partition. If you select Create New Partition, you can edit the New Partition Name field to specify the name of a new partition. Only available if Exclusive is on.

New Partition Name

Specifies the name of a new partition that will include the deformer set. The suggested partition name is deformPartition, which will be created if it does not already exist. Typically, you might put all your exclusive deformer sets in the partition named deformPartition. However, you can create as many partitions as you like, and name them whatever you want. Only available if Exclusive is on.