Node behavior

 
 
 

To change node behavior, select the node and expand the Node Behavior section of the Attribute Editor.

Caching

Turn Caching on to temporarily store input node evaluations in the cache. When Maya needs these evaluations (as input to the node), it uses the information stored in the cache rather than re-evaluating the input node. If no changes have been made to the node, it redraws more quickly. The cache is destroyed when you edit an attribute. Note that caching uses more memory, which could affect Maya’s performance.

Node State

Changing the node state can improve performance. There are six possible node states:

Normal

Causes the node to behave normally, according to the defined settings and effects. This is the default.

HasNoEffect

Disables any effects on the node so that fewer calculations are necessary at the time of redraw. The effect does not render until you reset the Node State back to Normal. Maya evaluates the nodes in the node’s history, but not the node itself.

For example, if you translate a cluster to deform a geometry, then set the Node State of the cluster node to HasNoEffect, the geometry appears undeformed, as though the translation had not occurred. To view the effect, change the Node State back to Normal.

Blocking

Temporarily hides the node and does not display the results of any input (input evaluations) to the node. This can speed the redraw. It is also useful when you have complex scenes and want to edit only one aspect of a node. Blocked nodes do not render.

For example, if you have a complex revolved surface and want to edit the curve, but don’t want to wait while the curve redraws, select Blocking and edit the curve. To display the modified revolved surface, reset the Node State to Normal.

Notes