Playing Shots
 
 
 

You can play shots in the Player from any menu in Lustre using either playback controls or hotkeys. To play shots, you must first load them into the Storyboard. See Moving Shots to the Storyboard.

You can also use a full-screen Player to view shots without the clutter of menus. This Player is particularly useful for viewing 2K footage at full resolution.

When you play shots in the Player, you can do the following:

NoteFor information on playing shots with audio, see Using Audio.

To play shots in a cut:

  1. Load your shots into the timeline. See Loading a Cut.
  2. Click the Play Mode button or press the . key (the decimal point on the numeric keypad) to cycle through playback range options.

    Show small imageShow large image

    (a) Playback controls  (b) Play Mode button  

    Select: To specify a looped playback range:
    Of the entire timeline.
    Of the current shot.
    Between in and out points.
    NoteFor control surface mappings, see the section that addresses toggling play mode in The Autodesk Control Surface, or in The Tangent CP100 Control Surface.
  3. To set in and out points, go to the start and end frame and mark the in and out points.
    Press: To:
    Shift+I Mark an in point.
    Shift+O Mark an out point.
    Shift+L Clear in and out points.
  4. Use the following playback controls or hotkeys to play your shot forward or backward.
    Click: Or press: To:
    Up Arrow Play the cut forward.
    Down Arrow Play the cut backward.
    N/A Stop playback.
    N/A Spacebar Start or stop playback in the direction last played.
    NoteFor information on navigating to a particular frame, see Navigating through Shots.