Use Auto Key to Block Out the Bounce
 
 
 

Auto Key provides an easy way to block initial animation.

A simple diagram illustrates the path of a bouncing ball.

The shape of the curve that the ball follows, its trajectory, affects the realism of the animation. So does the shape of the ball itself, which we’ll get to later in this lesson.

The default frame rate for 3ds Max Design is the NTSC (National Television System Committee) standard of 30 frames per second. If we want a single bounce of the ball to last one second, then it will fall for the first 15 frames, and rebound for the next 15 frames.

Set up the scene:

Use Auto Key to animate the ball falling:

  1. Click (Auto Key) to turn it on.

    The Auto Key button turns red to show that you are now animating.

    The time slider background and the border of the active viewport also turn red. Now when you move, rotate, or scale an object, 3ds Max Design creates keyframes that control the object’s motion.

    The time slider background and active viewport border turn red while you are animating.

  2. Make sure that (Select Object) is turned on, then click the basketball to select it.
  3. Drag the time slider to frame 15.

  4. In the Perspective viewport, right-click the basketball. Choose Move from the quad menu.
  5. Move the basketball vertically so it touches the floor, and even drops a little bit through the floor.

    The ball touches the floor at frame 15.

    (You will correct the intesection with the floor in a later procedure.)

    If you drag the time slider between frame 0 and frame 15, you will see that 3ds Max Design has animated the fall of the basketball. Red boxes appear on the timeline at both frame 0 and frame 15: these represent keys that 3ds Max Design created when you moved the ball.

    Keys appear on the timeline at frame 0 and frame 15.

Clone a key to complete the bounce:

You could drag the time slider to frame 30, and then move the ball upward so it approximately returns to its original position, but 3ds Max Design lets you position the ball more accurately than that.

  1. On the timeline, click the key at frame 0 to select it.

    The key turns white.

  2. Hold down the Shift key, then drag the key from frame 0 to frame 30.

    Shift+drag is a general method for cloning keys on the timeline. (Dragging a key without holding down Shift simply moves the key.) Now at frame 30, the ball is in precisely the position it was in at frame 1.

  3. Click (Auto Key) to turn it off.
  4. Drag the time slider to see the complete animated bounce.

In the animation you’ve just created, the ball moves down and then up, but the motion isn’t very bouncy: It looks stiff and computer generated. In the next section, you adjust key timing to make the bounce more realistic.

Next

Use the Curve Editor to Improve the Motion